Winding Tech Wire Mesh Demister With Diameter Less Than 800 mm

Winding Tech Wire Mesh Demister With Diameter Less Than 800 mm

Advantages in wire mesh pad demister:

Optimized solutions

Standard configurations

Tailored made configurations

Expedited services available

knowledge and engineering experience

High quality manufacturing standards and procedures

Manufactured in a variety of corrosion resistant materials (Metals, Plastics and Co-knit mesh options)

What can factory do for you in the mesh pad demister?

1. demister is tailor made to suit for specific vessel dimensions and configuration.

2. provides wide variety of material to suit for even the most corrosive process environments.

3. factory can supplies either mesh pad only, or complete demister with top and bottom supporting grids for direct installation in vessels.

4. Sectional construction for easy handling and access through man ways.

5. Complete accessory pack including support ring and beam can be provided when required.

When Mesh Pad Demister should be replaced?

Due to the fact that the mesh pad demister is normally installed in a major process line, it is almost impossible to replace them while the lines are in operation. Therefore, for economy purpose, it is important to have them replaced during annual or periodic shut-down period. For these reasons, the followings are presented for the user’s consideration.

When the thickness has changed.

When the tightness of each pad sections has changed.

When the corrosion of the wire is severely noticed.

When the entrained mist or dust gives pressure drop hazard.

Others as having been experienced by maintenance engineers.

Demister Inquiry Table when Calculation Suggestions and Service is needed:

Please pay attention to the Unit when refering to this sheet.

Package & shipping of bracketed wire mesh demister pad:

 

 
Welcome your inquiry with any questions! Here in we are always ready to be helpful!