|Surface Area:||500 M2/m3||Clination:||30 Degrees, X Type|
|OEM:||Available||Material:||SS304, SS316L, Titanium|
|Height:||100mm, 150mm, 200mm Per Layer||Surface Treatment:||Perforation, Corrugation|
DN350mm Tower Packing,
BX500 Wire Mesh Tower Packing,
OEM Tower Packing
DN350 - 200mm Tower Packing BX500 wire mesh type in carton
Applications of metal structured packing:
Hualai structured packing products list (part):
|Types of packing||Specific Surface||Void Fraction||Application|
|Wire gauze 500X||500||98.8%||
head pressure < 300 mbar
|Wire gauze 700Y||700||98.4%|
|Metal sheet 125X/Y||125||99.5%||High liquid and gas load|
|Metal sheet 250X/Y||250||98.8%||Standard|
|Metal sheet 350X/Y||350||98.3%||Higher NTSM at lower capacity|
|Metal sheet 500X/Y||500||97.7%||High NTSM|
|Metal sheet 700X/Y||700||97.0%|
Structure of packed tower using BX 500 wire mesh type packing
The packed tower is a continuous contact gas-liquid mass transfer equipment, which is composed of tower shell, packing, tower internals, gas-liquid inlet and outlet pipe fittings, etc.
The packing is the gas-liquid mass transfer element in packed tower, which determines the gas-liquid flow and contact transfer mode in the tower. Therefore, the material, structure and size of packing all affect the effective surface area and mass transfer coefficient of mass transfer, and determine the adaptability, effectiveness and economy of mass transfer process. There is a filler support under the filler to bear the weight of the filler. There is a liquid distributor above the packing, whose function is to evenly distribute the inlet liquid on the whole cross-section of the packing and keep a good initial distribution. Due to the wall effect of liquid in the packing layer and the formation of channel flow, the liquid redistributor should be set in the middle of the high packing layer to make the liquid redistribute evenly.
When the thin layer of high porosity packing is placed in the large diameter tower, the gas flow distribution on the cross section of the tower is not uniform, which affects the mass transfer efficiency of the packing. At this time, the inlet gas distributor should be set to make the high-speed gas flow in the feed pipe evenly distributed on the cross-sectional area of the tower.
In order to prevent the high-speed air from blowing or blowing up the packing layer, the top of the packing layer is provided with a packing pressing ring or a bed layer limiter. In addition, a liquid collector is required to lead out the side line.
How Hualai Manufactures Wire Mesh Type Packing?
Welcome your inquiry about Hualai structured packing any time!
Contact Person: Seven Zhao